How to Slowly Release AR-15 Bolt for Bore Sight
Bore sighting your AR-15 is an essential step in ensuring accuracy and precision when shooting. It involves aligning the sights of your rifle with the bullet path through the barrel. However, the process of removing and replacing the bolt can sometimes be tricky, especially if you are not familiar with the procedure. In this article, we will guide you through the steps on how to slowly release the AR-15 bolt for bore sighting.
Step 1: Prepare Your AR-15
Before you begin, make sure your AR-15 is unloaded and the magazine is removed. This is crucial for safety reasons. Place the rifle on a stable surface, such as a table or bench, to ensure it doesn’t move during the process.
Step 2: Locate the Bolt Catch
The bolt catch is a small lever located on the left side of the lower receiver. It is designed to hold the bolt in place when the rifle is not in use. To release the bolt, you need to press the bolt catch to the rear.
Step 3: Press the Bolt Catch
Using your thumb, press the bolt catch to the rear until you hear a click. This indicates that the bolt catch has been engaged and is now holding the bolt in place.
Step 4: Pull the Bolt Handle
With the bolt catch engaged, you can now pull the bolt handle to the rear. The bolt handle is located on the right side of the lower receiver. As you pull it back, the bolt will come out of the receiver.
Step 5: Remove the Bolt
Once the bolt is out of the receiver, you can now gently remove it from the bolt carrier group. Be sure to hold the bolt carrier group steady to avoid damaging the parts.
Step 6: Inspect the Bolt and Bolt Carrier Group
Before reassembling the bolt, it’s essential to inspect both the bolt and the bolt carrier group for any signs of damage or wear. If everything looks good, you can proceed to the next step.
Step 7: Reassemble the Bolt
To reassemble the bolt, simply place it back into the bolt carrier group and ensure it is properly seated. Then, push the bolt handle forward until it locks into place.
Step 8: Replace the Bolt in the Receiver
With the bolt reassembled, push it back into the receiver until it is fully seated. Make sure the bolt is fully engaged with the bolt catch.
Step 9: Check the Bore Sight
Now that the bolt is in place, you can proceed with bore sighting your AR-15. Ensure the sights are properly aligned and make any necessary adjustments to achieve the desired accuracy.
Conclusion
Following these steps will help you safely and effectively release the AR-15 bolt for bore sighting. Always prioritize safety and take your time when working with firearms. By understanding the process, you can ensure that your AR-15 is always in top condition and ready for action.
